Car hard to start when engine is cold
In winter or during the cold season, many people find it challenging to start their cars. The reasons are different for all since the process of starting the engine is influenced by many factors.
Such a problem can be if: a weak battery, bad fuel pump, non-working plugs or temperature sensor, or thick oil, but there are also a number of other faults.
If the starter motor starts well when you turn the key, look for a problem with the electronic sensors or the fuel system.
Causes of hard starting when the engine is cold
It is important to distinguish situations, why is my car hard to start when the engine is cold:
- the car is hot and does not start well;
- it does not start after idle time when it is cold (especially in the morning)
- refuses or long start in cold weather.
The causes should be considered separately for each case because the problems are different. All the reasons that lead to a bad cold start of an engine are considered in the table below:
Causes | Carburetor | Injector | Diesel |
---|---|---|---|
Poor fuel pump operation | ✓ | ✓ | ✓ |
Low fuel pressure | X | ✓ | ✓ |
Low fuel level in carburetor | ✓ | X | X |
Fuel line pressure regulator is defective | X | ✓ | ✓ |
Air suction | ✓ | ✓ | ✓ |
Poor spark plug condition | ✓ | ✓ | ✓ |
Malfunction of high-voltage wires or ignition coils | ✓ | ✓ | X |
Dirty idle valve | ✓ | ✓ | ✓ |
Defective air sensor reading | X | ✓ | ✓ |
Engine temperature sensor glitch | X | ✓ | ✓ |
Wrong valve timing or camber clearance | ✓ | ✓ | X |
Oil viscosity not correct (too thick) | ✓ | ✓ | ✓ |
Low battery charge | ✓ | ✓ | ✓ |
There are even rarer problems, but no less important. We will also mention them below.
What to do if the injector car struggles to start when the engine is cold
The first thing you should pay attention to when the injector car is working poorly is the sensors. Failure of some of them leads to difficulty starting the engine because the wrong signals are sent to the ECU unit. Usually, it is difficult to start in the cold because of:
Coolant temperature sensor defective
- the coolant temperature sensor, coolant temperature sensor informs the control unit about the state of the coolant, these indicators affect the engine start (unlike the carbureted car), adjusting the composition of the working mixture;
- throttle valve sensor;
- fuel flow sensor;
- air mass flow sensor (or inlet manifold pressure sensor).
If everything is OK with the sensors, it is worth checking the following assemblies:
- Often there is a problem with a cold start due to the fault of the fuel pressure regulator. Well and of course, whether injector or carburetor, when a cold car poorly starts, if it jerks, spikes in rpm, and after heating all right, then check the state of the plugs, and multimeter checks the coil and spark plug wires.
- Many problems are caused by leaky injectors, when it is hot outside, the car will start badly on a hot engine, and in the cold season, a dripping injector will be the reason for a hard start in the morning. To check this theory, it is enough to simply bleed pressure from the fuel system in the evening, so there will be nothing to drip and look at the result in the morning.
- One may not exclude such a trivial problem, as air drain in the fuel system — makes the start of a cold motor more difficult. Also pay attention to the fuel in the tank, because its quality greatly affects engine starting.
On cars such as Audi 80 (with mechanical injector), first of all, check the starter injector.
Why a carbureted engine doesn't start well in the cold
Most of the reasons why a carburetor engine starts poorly in the cold, or does not start at all, is due to malfunctions of the ignition system elements such as: spark plugs, spark plug wires, coil or battery.
Therefore, the first thing to do is to unscrew the spark plugs — if they are wet, then the electrical system is to blame.
The main reasons why the carburetor does not start in the cold:
Trambler malfunction is the main reason why the carburetor does not start well when cold
- Ignition coil.
- Commutator.
- Trambler (cover or slider).
- Improperly tuned carburetor.
- Damaged starter diaphragm or gas pump diaphragm.
Of course, if before starting pump up the gasoline and pull out a bigger suction pump, it starts better.
But, all these tips are relevant when the carburetor is properly configured and there are no problems with the commutator or spark plugs.
When the cold engine carburetor engine does not start — you need to smoothly press the gas pedal to the stop, twist the starter and release the pedal back, as soon as it grabbed, keep the gas in the same position until warmed up.
Let's take a look at some typical cases of not starting in the cold:
- when the starter cranks, but does not grab — it means either there is no ignition on the plugs, or there is no gasoline coming in either;
- if it picks up but does not start — most likely, the ignition has been knocked out or, again, there is no gasoline;
- if the starter does not start at all, there is probably a problem with the battery.
If everything is normal with oil, plugs and wires, it is possible that the ignition is late or the starter valve in the carburetor is not adjusted. However, there may be a torn diaphragm in the cold start system, and the adjustment of the valves also says a lot.
To quickly find the cause of poor starting a cold engine with a carburetor power system, experts recommend checking first of all: spark plugs, high-voltage wires, carburetor starting device, idle jets, and then also inspect the chopper contacts, ignition advance angle, gasoline pump and vacuum booster tubes condition.
Poor starting in the cold diesel (causes and tips for elimination)
As you know, starting a diesel engine is due to temperature and compression, so if there are no problems with the battery and starter, there may be 3 main ways to find the reason why the diesel does not start well in the morning in the cold:
Insufficient compression
- Insufficient compression.
- No spark plug ignition.
- Missing or disturbed fuel supply.
One of the reasons why the diesel engine does not start in the cold in particular, and poor starting of the diesel engine in general is poor compression. If in the morning the engine does not start, but picks up from a push start, and then a certain amount of time there is a bluish smoke, this is 90% low compression.
No less common case, when the owner of a car with a diesel engine can not start a cold engine, but a hot one starts without problems — if there is no glow on the candles. They carry out the heating of the diesel fuel until the diesel is completely at operating temperature.
There can be three options as to why the spark plugs do not work:
Glow plugs are damaged
- The plugs themselves are faulty.
- The problem is in the spark plug relay. Its operation is regulated by the indicators of the coolant temperature sensor. In normal operation, the relay makes a quiet clicking sound when you turn the key in the ignition before starting, and if you do not hear it, you should find it in the unit and check it.
- oxidation of the glow plug connector. Here, it is not necessary to explain how oxides affect the contact.
To check the diesel glow plugs, you can choose several ways:
- measure their resistance (on an unscrewed spark plug) or breakage of the heating circuit with a multimeter (checked in squeaker mode, both screwed into the engine and unscrewed);
- check the rapidity and degree of heating on the battery by connecting to the mass and the central electrode with wires;
- without unscrewing it from the engine, connect the central wire to the plus terminal of the battery through a 12 volt bulb.
If the plugs are working, and they are properly powered when the ignition is turned on, in some cases it is necessary to check the valve gaps. After warming up, they come back to normal and the engine starts normally when hot.
Check glow plugs
Defective diesel injectors, as a result of natural wear or contamination. In some cases, the injectors are dumping a lot of fuel into the return.
Fuel outages are much more troublesome to start the engine. So, if the diesel stops starting in the morning no matter what the temperature is, it's either the fuel going out (the valve on the return isn't holding) or it's sucking air, the other options are less likely! Air in the fuel system can cause the diesel to start badly and stall.
The fuel is not in season. When it's cold outside and the diesel engine won't start or immediately stalls after starting, then the problem may be the fuel. At temperatures below 0 Celsius, the summer grade of diesel fuel thickens in the fuel system. It is necessary to use diesel fuel according to the season. In such a case, heating the fuel system and changing the fuel filter will help to start the diesel.
Tips for diesel car owners:
- After pouring boiling water on top of the fuel filter, the car will start and run normally — the fuel is summer.
- If there is low pressure in the fuel rail it means the injectors are probably pouring, they are not closing (check their work at a special stand).
- If the check showed that the injectors are pouring back, the needle in the atomizer does not open (it is necessary to change them).
10 reasons why the diesel does not start well in cold conditions
If the diesel does not start well in the cold, the causes can be gathered in a single list of ten points:
Why Diesel Engines Are Difficult to Cold Start: video
- Faulty starter or battery.
- Insufficient compression.
- One injector/several injectors malfunction.
- Incorrect injection timing, timing mismatch with high-pressure fuel pump (timing belt jumped one tooth).
- Air in fuel.
- Valve clearance set incorrectly.
- Faulty preheating system.
- Additional resistance in the fuel system.
- Additional resistance in the exhaust system.
- Internal failure of the fuel injection system.
We hope, all the above will help you, and if not solve the problem with the cold start engine, then at least directs you to the right way of its elimination by your own efforts or with the help of a specialist.
How do you fix a cold start problem?
To overcome the difficult starting a cold engine can only eliminate the identified problem, but there are a few general tips that will help solve this problem.
On gasoline engines, the indicator that bad starts and stalls in the cold, can be a spark plug. Unscrew it, look: if poured — overflowing, look for the points further; if dry — lean mixture, also go through the options. This method of analysis will allow you to begin with the simpler findings and gradually approach the more complex causes of poor engine starting in the cold, and not look for them in the fuel pump, disassemble the injector, get into the mechanism of the timing, open the cylinder block, etc.
But the diesel engine will have poor compression first in the list of faults. So, the owners of diesel automobiles should pay heightened attention to it. The second place is occupied by the quality of fuel or its inappropriateness for the season, and the third place is the glow plugs.